![]() Press any button to display configuration options and enter Configure mode (the LCD displays "Setup Mode? Manual").ģ.) Press the Down button to display the IP address.Ĥ.) Press the Enter button to enter Edit mode (cursor changes to a blinking box).ĥ.) Using the right and left buttons, position the cursor over the characters and press the up or down buttons to change them.Ħ.) When finished, press the Enter button to save changes and return to Configure mode.ħ.) Repeat steps 4 through 6 to specify the subnet mask, gateway address, DNS address, console password, and enable password.Ĩ.) When the LCD reads "Console Password: Push to set", press the Enter button to display an auto-generated password. To configure the ProxySG using the front panel:ġ.) Connect the ProxySG to power and toggle the power switch (on models without power switches, the appliance will power on immediately).Ģ.) When the boot cycle finishes, the LCD displays IP address not configured. This document will describe the changes necessary for both methods. If you do not have an LCD screen, you will need a null modem cable to make your changes. Depending on the model of the ProxySG, you may have an LCD screen where you can make changes. ![]() ![]() In order to reset the enable password on the ProxySG, you will need to have physical access to the ProxySG itself. How do I reset the console user password? Resolution ![]() How do I recover from a forgotten enable password? How do I reset the enable password on the ProxySG? ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |